Envoy Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
Envoy
Envoy Configuration and Management Manual—429861-001
5-29
INFO LINE Command
No Parity Check
indicates if no parity check is ON or OFF.
Break Enable
indicates if break enable is turned ON or OFF.
TPause
indicates whether the communications line interface processor (CLIP) should
monitor for SCTS during data transmission. If the SCTS signal is present, the CLIP
will resume transmission when SCTS is dropped.
Tchar1 - Tchar4
specifies up to four termination or strip characters (TCHAR settings) by using
TCHAR1, TCHAR2, TCHAR3, and TCHAR4.
Etx Char
indicates if the end-of-text (ETX) termination character is set.
Cntl Term
determines how a read is terminated.
Duplex
indicates if the line is full-duplex or half-duplex.
Async Intf
defines the electrical connection type as EIA RS-232 or CL (current loop).
Dual212
if ON, this indicates that the speed of the modem should be automatically sensed
through the secondary carrier (SCF).
Dsr Sense
if ON, indicates if the loss of a DSR modem signal is sensed during a READ or
WRITE operation.
WaitDsrDrop
if ON, indicates that a drop DTR request will wait indefinitely for the DSR to come
down.
Retries
specifies the number of retries per request for all lines.