Envoy Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
Envoy
Envoy Configuration and Management Manual—429861-001
5-30
INFO LINE Command
Timeout
specifies the processor input/output (I/O) timeout.
Threshold
specifies the statistics threshold value used to generate statistics events.
Table 5-5
shows the device types and subtypes, protocols, and profiles associated with
Envoy line types.
Note. In the displays for the INFO command, an asterisk (*) indicates that the value of the
attribute can be changed with the ALTER command.
The term NO^SPECIAL listed next to Interrupt Handler indicates that the system’s interrupt
handler is being used, rather than an Envoy interrupt handler.
Table 5-5. Types, Subtypes, Protocols, and Profiles of Envoy Lines (page 1 of 2)
Device
Type
Device
Subtype Protocol
Profile
Name Line Types
7 0 BSC PENVBSC Byte-synchronous, point-to-point,
non-switched
1 BSC PENVBSC Byte-synchronous, point-to-point,
switched
2 BSC PENVBSC Byte-synchronous, multipoint,
tributary
3 BSC PENVBSC Byte-synchronous, multipoint,
supervisor
8 ADM PENVADM ADM-2, multipoint, asynchronous,
supervisor
9 TINET PENVTIN TINET, multipoint, asynchronous
supervisor
10 BSC PENVBSC Burroughs, byte-synchronous,
multipoint, supervisor
ASC PENVASC Burroughs, asynchronous, multipoint,
supervisor
13 BSC PENVBSC Burroughs, byte-synchronous,
point-to-point, contention
ASC PENVASC Burroughs, asynchronous,
point-to-point, contention
30 BSC PENVBSC Full-duplex, byte-synchronous,
outgoing