Envoy Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
Envoy
Envoy Configuration and Management Manual—429861-001
5-41
START LINE Command
START LINE Command
The START LINE command initiates the operation of an line. The successful
completion of the START LINE command leaves the line in the STARTED state. This is
a sensitive command.
The command syntax is as follows:
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file.
LINE line-name
designates the line to be started. If you omit line-name, the assumed line is started
(for information about the ASSUME command, see the SCF Reference Manual for
G-Series Releases).
Examples
The following command starts the line named $ENV01.
-> START LINE $ZZWAN.#ENV01
START [ / OUT file-spec / ] [ LINE line-name ]