Envoy Configuration and Management Manual

Subsystem Control Facility (SCF) Commands for
Envoy
Envoy Configuration and Management Manual—429861-001
5-49
STOP DEVICE Command
STOP DEVICE Command
The WAN subsystem STOP DEVICE command stops a data communications subsystem
object.
The command syntax is as follows:
device-name
indicates the name of the DEVICE object in the configuration database and is also
the name of the corresponding data communications subsystem object, as specified
in the ADD DEVICE command. You can use the asterisk (*) to specify all
configured DEVICE objects.
Considerations
•
The DEVICE object will stop normally before the DEVICE object is placed in the
STOPPED state.
•
The STOP DEVICE command stops the data communications subsystem object by
removing the object from the processor pair it was running in. Any pending requests
will then terminate with an error. The data communications subsystem object can be
recreated with the START DEVICE command.
Example
The following command stops the device named #ENV01.
-> STOP DEVICE $ZZWAN.#ENV01
STOP DEVICE $ZZWAN.#device-name