Envoy Configuration and Management Manual

Tr acing
Envoy Configuration and Management Manual—429861-001
6-9
STATETABLES Command
Considerations
•
If no SELECT command is entered, all records are selected.
•
The RESET and FROM commands reset the mask to ALL.
STATETABLES Command
The STATETABLES command specifies the name of the file to be used to display the
state-machine labels.
The command syntax is as follows:
file-name
is a Guardian 90 disk file. This file must be an existing unstructured file (file code
830).
Consideration
The state-machine labels table is no longer accessible after the execution of the RESET
and FROM commands. See the FROM command description in this section for
information about the condition when the reset occurs, and for information about the
automatic invocation of the STATETABLES command.
MEMUSE 25 All memory allocation and deallocation
MISC1 26 Miscellaneous 1
MISC2 27 Miscellaneous 2
MDMSTATE 28 Modem state
POLL 29 Poll list
PSM 30 Protocol state machine
PSMENTRY 31 Protocol state-machine entry
PSMEXIT 32 Protocol state-machine exit
REQRCVD 33 Requests received
STATETABLES file-name
Note. The trace file size is limited to 70K bytes on disk. When the file is full, the trace will
automatically be stopped. The WRAP option allows the trace records to wrap around in the file.
Specify WRAP if you expect the data to exceed 70K bytes.
Table 6-3. Select Option Keywords for Envoy (page 2 of 2)
Keyword Value Enables tracing of...