Envoy Configuration and Management Manual

Envoy Configuration and Management Manual—429861-001
A-1
A
Envoy Subsystem Error Messages
This section describes network-related operator console and common file-system error
messages, such as those that might occur because of a typographical error.
All subsystem-specific SCF error messages returned by the Envoy subsystem are listed
and described. These errors all have positive error numbers. Errors returned by the
Envoy subsystem that have negative numbers are SCF errors common to all subsystems.
The common error messages are described in the SCF Reference Manual for G-Series
Releases.
Common Versus Subsystem-Specific Errors
SCF provides a pool of error messages, called common errors, that can be used by all
subsystems. These errors always have negative error numbers. Your subsystem may use
these common errors.
Your subsystem also can generate error messages, called subsystem-specific errors, that
pertain solely to that system. These errors always have positive error numbers.
For each error, therefore, you must look at the subsystem identifier to see which
subsystem returned the error, and look at the error number to determine whether it is a
common error or a subsystem-specific error.
Example of Envoy Error
The following error, for example, can be returned by the Envoy subsystem and is
specific to the Envoy subsystem. No other subsystem generates this same error number
and text. Cause, effect, and recovery information for this error is given later in this
appendix. Note that the error number is a positive number.
Example of Common Error
The following error, in contrast to the one above, can also be returned by the Envoy
subsystem, but the error number and text is common to all subsystems using SCF. In
other words, many other subsystems might also use this same -00001 error number and
text. Additional information on this error is given in the SCF Reference Manual for
G-Series Releases. Note that the error number is a negative number.
ENVOY E00001 Trace Backup command rejected; backup process is
not available.
ENVOY E-00001 Already using resource-name