Envoy Configuration and Management Manual

Envoy Subsystem Error Messages

Envoy Configuration and Management Manual—429861-001

A-4

E000014

Cause. ALTER command rejected; attribute attr value is not supported.

Effect. The attribute will not be changed to the new value that you entered.

Recovery. Make sure that the correct value is being specified for the attribute.

E000015

Cause. The incorrect ALTER attribute set name was specified in the ALTER LINE

command. ALTER attribute set names are ASC, ASCNET, BSCPTP, BSCMPSUPV,

BSCMPTRIB, BSCBURPTP and FDX.

Effect. The ALTER command is rejected.

Recovery. Retry the command with the correct ALTER attribute set name. The correct

ALTER attribute set name can be found in the INFO LINE, DETAIL display.

E000017

Cause. The call to Guardian to allocate a buffer was unsuccessful. The system may be

too busy or the dedicated buffer memory segment may be out of space.

Effect. The ALTER command is rejected. The previous buffer size is retained.

Recovery. Specify a smaller buffer size and retry the ALTER command.

E000510

Cause. A call to Envoy IOP to switch the primary CPU to the backup was unsuccessful.

The CPU number given in the PRIMARY command was already the primary CPU.

Effect. The PRIMARY command did not execute. The primary CPU remains the same.

Recovery. None. The desired CPU is already primary.

ENVOY E000014 Alter command rejected; attribute attr value is

not supported.

ENVOY E000015 Alter command rejected; the attribute set name

specified is invalid for this line.

ENVOY E000017 Alter command rejected; unable to allocate

dedicated buffer.

ENVOY E000510 Already using.