Envoy Configuration and Management Manual

Envoy Event Messages
Envoy Configuration and Management Manual—429861-001
B-8
5: ZENV-EVT-IOPROCABENDMESS
ZENV-VAL-ABEND-OMR-GET
Unable to get OMR through IOPRM. The error-dependent portion of the
message displays the error number:
Returned Error #error number
ZENV-VAL-ABEND-PROCESS-INFO
Unable to get Envoy phandle. The error-dependent portion of the message
displays the error number:
Returned Error #error number
ZENV-VAL-ABEND-UNITS-ERR
For a line defined with two units, the I/O process was not able to locate the
Write and Read unit pairs. A probable cause is that the Write unit was not
defined as the even-numbered unit. This message has no error-dependent
portion.
ZENV-VAL-ABEND-UNITS-PER-LINE
The number of units specified for the line is incorrect. The error-dependent
portion of the message displays the number of units being used:
Required Number of Units number of units
ZENV-VAL-ABEND-UNKWN
Unknown abend cause. There is no error-dependent portion.
ZENV-VAL-ABEND-UNKWN-CTLR
A controller type not supported by Envoy was defined for the line. The error-
dependent portion displays the controller type:
Controller type controller type
ZENV-VAL-ABEND-UNKWN-DRV
An unknown driver was defined for the line. There is no error-dependent
portion. The following drivers are acceptable.
ASYNC^DRIVER
BISYNC^DRIVER
FDX^NAQ^DRIVER
FDX^DRIVER
ASYNC^DRIVER
SIMPLEX^DRIVER
ZENV-VAL-ABEND-UNKWN-INTHDLR
An unknown special interrupt handler was defined for the line. There is no error-
dependent portion. Only the following interrupt handlers are allowed: