Envoy Configuration and Management Manual

Envoy Event Messages
Envoy Configuration and Management Manual—429861-001
B-31
-00003: ZCOM-EVT-SUMSTATE-CHANGE
ZCOM-TKN-OLD-OBJSTATE
Contains the previous summary state of the process, which could be one of the
following values:
ZCOM-VAL-SUMSTATE-STOPPED
ZCOM-VAL-SUMSTATE-STARTED
ZCOM-TKN-CAUSE-SUMSTATE-CHG
Indicates the cause of the state change, which could be one of the following values:
ZCOM-VAL-HW
Hardware-caused state change
ZCOM-VAL-OP-REQ
Operator-request state change
ZCOM-VAL-UKWN
Unknown cause
ZEMS-MAP-EXIOADDR
Contains the physical I/O address.
Probable Cause
The I/O PROCESS has received an operator-initiated request whose successful
execution resulted in a state change.
The following operator-initiated requests may result in a state change:
•
TSM ABORT/START/STOP
System Action
The I/O PROCESS has changed to the indicated state.
Recovery
Not applicable.
Consideration
This event is a common communications subsystem event.