Envoy Configuration and Management Manual

S-Series Changes to Envoy
Envoy Configuration and Management Manual—429861-001
D-4
Unit Numbers
Unit Numbers
While adding the device, unit number is not required, except for lines of subtype 30, 31,
32 and 33.
FDX Line Changes
Starting from this release, FDX lines (Write and Read) need to be MULTIed on a single
line of any CLIP so as to get the same effect as that of COUPing these lines on units n
and n+1 of a 3602 controller (where n = 0, 2, 4, 6)
No Support for Auto-Call Unit
ACU is not supported in G-series releases.