Envoy Configuration and Management Manual

WAN Subsystem Profiles and Modifiers for Envoy
Envoy Configuration and Management Manual—429861-001
3-18
Modifier Descriptions
This modifier applies to all Envoy line types. It causes all event messages to be sent to
the console, regardless of the value of the ZEMS-TKN-CONSOLE-PRINT token.
EMSOFF
Default: EMSOFF
Units: Not applicable
Range: Not applicable
Alternate modifier: EMS
This modifier applies to all Envoy line types. It causes event messages to be sent to the
console as determined by the value of the ZEMS-TKN-CONSOLE-PRINT token.
ERRDIFF
Default: NOERRDIFF
Units: Not applicable
Range: Not applicable
Alternate modifier: NOERRDIF
This modifier applies to BSC lines only. It defines the error code to be returned when a
response to a line bid or to text is not received. Different error codes are returned for the
no-response conditions. An error 171, No response on Bid/Poll, is returned when a
response to a line-bid condition is not detected. An error 162, Timeout, is returned when
a response to text is not detected.
ETX n
Default: 3
Units: Not applicable
Range: Not applicable
Alternate modifier: None
This modifier applies to SIMPLEX and ASC lines only. It sets the End-of-Text (ETX)
termination character.
If a TCHARn modifier is specified, it overrides the ETX character.
EVEN
Default: EVEN for ADM and TINET lines; NONE for SIMPLEX and ASC lines
Units: Not applicable
Range: Not applicable