Envoy Configuration and Management Manual

WAN Subsystem Profiles and Modifiers for Envoy
Envoy Configuration and Management Manual—429861-001
3-38
Modifier Descriptions
TPAUSE
Default: Not specified
Units: Not applicable
Range: Not applicable
Alternate modifier: None
This modifier applies to SIMPLEX and ASC lines only. It causes the communications
line interface processor (CLIP) to monitor for SCTS during data transmission. If the
SCTS signal is present, the CLIP resumes transmission when SCTS is dropped.
Once this modifier is added to the device record, it can only be removed by using the
SCF ALTER DEVICE command with the RESET modifier option.
TRACE
Default: TRACEOFF
Units: Not applicable
Range: Not applicable
Alternate modifier: TRACEOFF
This modifier applies to all Envoy line types. It causes the Envoy subsystem to begin a
trace when the Envoy line-handler process is started. The trace file is located in
$nnn.ZENVTRnn.line-name where the volume is that contains the Envoy program file
and nn is the processor number. This modifier should only be used for debugging
purposes.
TRACEOFF
Default: TRACEOFF
Units: Not applicable
Range: Not applicable
Alternate modifier: TRACE
This modifier applies to all Envoy line types. It causes the Envoy subsystem not to begin
a trace when the Envoy line-handler process is started.
TWOUNIT
Default: TWOUNIT for BSC lines; ONEUNIT for other line types
Units: Not applicable
Range: Not applicable
Alternate modifier: ONEUNIT