Ethernet Adapter Installation and Support Guide

Relocating an E4SA
Ethernet Adapter Installation and Support Guide—425684-003
4-20
Locate the New Slot
5. Verify that the E4SA ADAPTER object is in the STOPPED state.
Use the SCF STATUS ADAPTER command:
STATUS ADAPTER $adapter-name
Example 4-25 shows the output of this command. Note that the ADAPTER
(E0153) is in the STOPPED state.
Locate the New Slot
Find the group, module, and slot containing the E4SA you want to move and the empty
slot to which you want it moved. The empty slot contains a double-high filler panel.
(Figure 4-3 on page 4-21 shows the E4SA slot locations.)
Remove the double-high filler panel from the slot to which you want to move the E4SA.
Set the filler panel aside. You will reinstall the filler panel in the slot left vacant by the
E4SA you move.
Label the Communications Cables Connected to the E4SA
To label communications cables for an E4SA:
1. Find the group, module, and slot in which the Ethernet 4 ServerNet adapter (E4SA)
is installed.
Figure 4-3 on page 4-21 shows the E4SA slot locations.
Example 4-25. SCF STATUS ADAPTER Command
->STATUS ADAPTER $ZZLAN.E0153
SLSA Status ADAPTER
Name State
$ZZLAN.E0153 STOPPED