Ethernet Adapter Installation and Support Guide

Relocating an E4SA
Ethernet Adapter Installation and Support Guide—425684-003
4-27
Remove and Install the Adapter
9. Press the blue-green tab on the E4SA ejector and latch the ejector to seat the
E4SA against the backplane.
10. Disconnect the grounding clip of your ESD wriststrap from the enclosure.
11. Install the double-high filler panel in the slot left vacant by the E4SA you moved.
12. Connect the RJ-45 connectors to the Ethernet ports on the E4SA. Connect the
other ends of the cables to your Ethernet hub. Use the labels on the cables to
make sure you connect each cable to the proper port and Ethernet hub.
Figure 4-9 on page 4-28 shows the connection of the communication cable
between the E4SA and vendor Ethernet hub.
Figure 4-8. Installing an E4SA
058CDT .CDD