Ethernet Adapter Installation and Support Guide

Relocating an E4SA
Ethernet Adapter Installation and Support Guide—425684-003
4-29
Check the Installation of the E4SA
Check the Installation of the E4SA
To check the installation of an E4SA:
1. Make sure that the power-on LED (green light) is on.
Figure 4-10 on page 4-30 shows the location of the power-on LED and fault LED.
2. If the power-on LED does not come on, do one or both of the following:
•
Reseat the E4SA.
•
Check the E4SA and backplane connector for damaged pins.
Note the Following Error Conditions
•
If the power-on LED does not come on after you reseat the E4SA, you must
replace the E4SA
•
If the E4SA or backplane connector have damaged pins, both the E4SA and
backplane (or enclosure) must be replaced. For backplane replacement
instructions, refer to the HP NonStop S-Series Service Provider Supplement.
Note. When the adapter is inserted, the fault LED (amber) remains on until the service
processor has completed its start-up configuration. The fault LED also comes on when
SLSA detects a POST failure.