Ethernet Adapter Installation and Support Guide

Replacing an E4SA
Ethernet Adapter Installation and Support Guide—425684-003
3-18
Abort the E4SA
Abort the E4SA
To abort an E4SA, perform the following:
1. Stop access to the logical interfaces (LIFs) associated with the Ethernet 4
ServerNet adapter (E4SA) to be replaced.
Use the SCF ABORT LIF command for each LIF:
ABORT LIF $ZZLAN.lif-name
ABORT LIF $ZZLAN.lif-name
ABORT LIF $ZZLAN.lif-name
ABORT LIF $ZZLAN.lif-name
2. Verify that the LIFs associated with the E4SA to be replaced are in the STOPPED
state.
Use the SCF STATUS LIF command:
STATUS LIF $ZZLAN.*
Example 3-23 shows the output of this command. Note that the logical
interfaces (LIFs) are in the STOPPED state.
Example 3-22. SCF INFO ADAPTER Command
-> INFO ADAPTER $ZZLAN.E0153
SLSA Info ADAPTER
Name Group Module Slot Type
$ZZLAN.E0153 1 1 53 E4SA
Note. If Ethernet 4 ServerNet adapters (E4SA) are named using the HP Manufacturing
naming convention, you can easily identify the physical location of the E4SA by its name as
follows:
$ZZLAN.Ecabid-slot
where cabid is the two-digit number that identifies the enclosure and slot is the actual
physical slot number in the enclosure. For example, the E4SA named E0153 is located in
enclosure 01, slot 53. (See Manufacturing Naming Conventions
on page 1-8.)
Example 3-23. SCF STATUS LIF Command
->STATUS LIF $ZZLAN.*
SLSA Status LIF
Name State Access State
$ZZLAN.L018 STOPPED UP
$ZZLAN.L019 STOPPED UP
$ZZLAN.L01A STOPPED UP
$ZZLAN.L01B STOPPED UP