Ethernet Adapter Installation and Support Guide

Replacing an E4SA

Ethernet Adapter Installation and Support Guide—425684-003

3-33

Start the New E4SA

4. Start the logical interfaces (LIFs).

Use the SCF START LIF command for each LIF:

START LIF $ZZLAN.lif-name

5. Verify that the LIFs are in the STARTED state.

Use the SCF STATUS LIF command:

STATUS LIF $ZZLAN.*

Example 3-28 shows the output of the SCF STATUS LIF command. Note that

the logical interfaces (LIFs) are in the STARTED state.

Troubleshooting: If the E4SA SAC Object Is Still in the

STARTING State

If the SCF SAC STATUS command shows that the E4SA SAC object is still in the

STARTING state after a few minutes or if the TSM Service Application indicates that

the resource needs attention, do the following:

1. Check for event messages in the Event Message Service (EMS) log. Use the TSM

EMS Event Viewer Application to view the EMS log:

1. From the File menu, select Log on.

2. Select the system.

Example 3-27. SCF STATUS PIF command

->STATUS PIF $ZZLAN.E0153.*

SLSA Status PIF

Name State

$ZZLAN.E0153.0.A STARTED

$ZZLAN.E0153.0.B STARTED

$ZZLAN.E0153.1.A STARTED

$ZZLAN.E0153.1.B STARTED

Example 3-28. SCF STATUS LIF command

->STATUS LIF $ZZLAN.*

SLSA Status LIF

Name State Access State

$ZZLAN.L018 STARTED UP

$ZZLAN.L019 STARTED UP

$ZZLAN.L01A STARTED UP

$ZZLAN.L01B STARTED UP