Event Management Service (EMS) Analyzer Manual
Command Descriptions
Event Management Service (EMS) Analyzer Manual–133700
5-45
STATUS
Considerations
Information provided by this command is similar to what EMSDINFO provides at the
TACL prompt.
Examples
This is a sample of output for a consumer distributor (collector mode).
•
Distributor type is the type of distributor (CONSUMER, FORWARDING,
or PRINTING).
•
Filter is the name of the current filter to be used when searching for events. The
default filter for EMS Analyzer is EMSAFLTR.
•
PPID is the number of the CPU in which the primary process for the distributor is
running.
•
BPID is the number of the CPU in which the backup process for the distributor is
running if a backup exists. For the EMS Analyzer distributor, the backup CPU is not
configured.
•
Priority is the current execution priority of the distributor.
•
Last error is distributor error number last returned to a process communicating
with the distributor programmatically.
•
Current position is the log time (in local civil time) of the event message
last examined by the distributor.
•
Emslog is the name of the EMS log file from where the event messages are
sourced.
-> STATUS DISTRIBUTOR $DIST
-> STATUS /OUT OutStus/ DISTRIBUTOR $DIST
-> STATUS DISTRIBUTOR $Z467
EMSA STATUS DISTRIBUTOR $Z467
Distributor type. CONSUMER Filter..... $STING.EMSA.EMSAFLTR
PPID............. 02,074 BPID....... NOT CONFIGURED
Priority......... 149 Last error. 0
Current position. 91JUL25, 09:12:28
Emslog.............. $0.#ZSPI
Coll log............ $SYSTEM.ZLOG00.ZZEV0004
Current log......... $SYSTEM.ZLOG00.ZZEV0004
Coll state.......... IDLE
Coll IO status...... NO IO
Record address...... Block 293 Record 17
Coll event filtered. 2
Coll event total.... 16
Coll event logging.. IN PROGRESS
Event filtered...... 2
Event total......... 16
Event processing.... ACTIVATED