Event Management Service (EMS) Analyzer Manual

Command Descriptions
Event Management Service (EMS) Analyzer Manual–133700
5-48
STOP
This is a sample of output for a printing distributor.
•
Name is the name of the textout file. There can be up to 5 textouts.
•
Type is the type of the textout file.
•
State is one of the following: REMOVED (after error), IDLE, WAITING
ERROR, WAITING TIMEOUT or PRINTING.
STOP
The STOP command stops the specified object or objects.
/OUT file-spec/
causes any EMS Analyzer output generated for this command to be directed to the
specified file.
object-spec
designates the object or objects to be stopped. If object-spec is omitted, the
assumed object is stopped. See the EMS Analyzer ASSUME command.
Consideration
Any local distributor can be stopped with the STOP command, if you have an
appropriate security level.
-> STATUS DISTRIBUTOR $Z123
EMSA STATUS DISTRIBUTOR $Z123
Distributor type. PRINTING Filter.....
PPID............. 01,066 BPID....... NOT CONFIGURED
Priority......... 148 Last error. 0
Emslog.............. $0.#ZSPI
Coll log............ $SYSTEM.ZLOG00.ZZEV0004
Current log......... $SYSTEM.ZLOG00.ZZEV0004
Coll state.......... FETCHING EVENT
Coll IO status...... EVENT WAIT STATUS
Record address...... Block 298 Record 6
Coll event filtered. 0
Coll event total.... 0
Coll event logging.. IN PROGRESS
Textout
Name Type State
$S.#ZP 132 IDLE
$STING.EMSA.ALLO 80 IDLE
Event filtered...... 0
Event total......... 0
Event processing.... ACTIVATED
STOP [ /OUT file-spec/ ] [ object-spec ]