Event Management Service (EMS) Analyzer Manual

Error Messages
Event Management Service (EMS) Analyzer Manual–133700
E-20
Error Messages
EMSA 20312
Cause. The specified SSID is not valid. All the following attributes on the command
line, if there is some, are not altered.
Recovery. At the command prompt, type “OBEY EMSASSID”. This will give you all
valid SSIDs (owner.subsystem number).
EMSA 20313
Cause. The start time and stop time attributes are not sequenced properly, that is the
start time is after the stop time.
Recovery. Specify a start time before the stop time.
EMSA 20314
Cause. This attribute has already been modified earlier in this ALTER command. All
the following attributes on the command line, if there is some, have not been altered.
Cause. Specify attributes to be modified only once in the same ALTER command.
EMSA 20315
Cause. You used the START command to start a distributor and there is already a
distributor running. Only one distributor at a time can run into EMSA environment.
Recovery. Use the current running distributor, or stop it (see STOP
command) and
restart (see START command) another.
EMSA 20316
Cause. The distributor process cannot be found. It is a remote distributor, or the
distributor has been stopped.
Recovery. Specify a local distributor, or if it was the EMSA current distributor, start
(see START
command) a new distributor and select desired attribute values because all
the environment has been reset.
Invalid SSID
Sequence problem with start and stop time
Attribute \\\\\\\\\\\\ already modified
A distributor is already started
Communication problem with specified distributor