Event Management Service (EMS) Analyzer Manual

Error Messages
Event Management Service (EMS) Analyzer Manual–133700
E-25
Error Messages
EMSA 30307
Cause. The filter parameter was not removed or replaced from configuration because it
was not there.
Recovery. Contact your Tandem representative.
EMSA 30310
Cause. The maximum number of EMS source collectors loaded in configuration is
reached.
Recovery. EMS Analyzer allows only one EMS source collector at a time. Reset the
EMSLOG attribute to its default value ($0), then specify the desired EMS source
collector.
EMSA 30311
Cause. The TEXTOUT destination was not removed or replaced from configuration
because it was not there.
Recovery. Contact your Tandem representative.
EMSA 30312
Cause. A printing distributor has received more than the maximum (5) number of
requests for TEXTOUT destinations.
Recovery. Specify not more than the maximum (5) TEXTOUT destinations for a
printing distributor.
EMSA 30314
Cause. The distributor process cannot be found. It is a remote distributor, or the
distributor has been stopped.
Recovery. Specify a local distributor, or if it was the EMSA current distributor, start
(see START
command) a new distributor and select desired attribute values because all
the environment has been reset.
Filter parameter was not found in configuration
The list of EMS source collector is full
The TEXTOUT destination was not found
Maximum number of TEXTOUT destinations was reached
The distributor cannot be found