Event Management Service (EMS) Analyzer Manual

Error Messages
Event Management Service (EMS) Analyzer Manual–133700
E-36
Interprocess Communication Error Messages
-00006
Cause. The command sequence is invalid. A command was issued and cannot be
executed because of the current activity or state of the target object.
Recovery. This can be a warning or an error. Refer to the subsystem specific reference
manual for the subsystem with which you are communicating for information about how
that subsystem handles this error condition.
-00008
Cause. A command was issued and the byte-count read by the file-system procedure
(for example, READUPDATE) is smaller than the used-length value in the command
buffer.
Recovery. Contact your Tandem representative.
-00009
Cause. The command contained a syntactically invalid file-name.
Recovery. Correct the file name in error and reissue the request. See the reference
manual for file name format.
-00010
Cause. A procedure call to the file system failed during execution of a request. For
example, an OPEN was rejected by a process.
Recovery. Refer to the Guardian Procedure Errors and Messages Manual for recovery
procedures.
-00011
Cause. The file specified in the request has an invalid format.
Recovery. Determine the valid file type code for the target file and reissue the
command.
Command sequence invalid for <obj name>
Internal error: SPI buffer larger than expected for <obj
name>
Invalid file name: <file name>
File system error: <num>, call: <call>, file: <name>
Invalid type of file: <file name> for <obj name>