Event Management Service (EMS) Analyzer Manual

Using EMS Analyzer

Event Management Service (EMS) Analyzer Manual–133700

3-3

Running EMS Analyzer

•

Starting the Search

•

Altering the DUMPLOG STATUS Attribute

•

Removing the More Text Question

•

Examining Results

•

Making Enform Reports

•

Downloading Files to a Workstation

Running EMS Analyzer

EMS Analyzer follows the conventions of Tandem conversational interfaces, such as the

Subsystem Control Facility (SCF). If you have used other Tandem products with a

conversational interface, you will find EMS Analyzer easy to use and understand.

You can run EMS Analyzer interactively or noninteractively. The RUN

command to start

EMS Analyzer is described in this subsection. All the EMS Analyzer commands are

described in Section 5, Command Descriptions

EMS Analyzer reads events from the local collector ($0), an alternate collector, or from

an EMS event log file. You specify the event input source by using the ALTER

command.

EMS Analyzer directs its output to a terminal, the spooler, Enscribe database file, or a

CSV file.

If EMS Analyzer is installed in the $SYSTEM.SYSTEM or $SYSTEM.SYSnn

subvolume, you can type the following from any volume or subvolume to run EMS

Analyzer:

1> emsa

However, if EMS Analyzer is not installed in $SYSTEM.SYSTEM or

$SYSTEM.SYSnn subvolume, you must use the TACL VOLUME command to move to

the subvolume where EMS Analyzer is installed.

1> volume $vol.subvol

2> run emsa

At the beginning of an EMS Analyzer session, EMS Analyzer displays its product

banner, which includes the Tandem part number, version number, release date, and

invoked. This file is an OBEY

file including commands executed each time you run

EMS Analyzer (see Appendix C, EMSACSTM File).

Note. You do not have to be a super user to run EMS Analyzer.