Event Management Service (EMS) Analyzer Manual

Using EMS Analyzer

Event Management Service (EMS) Analyzer Manual–133700

3-4

Running EMS Analyzer

The EMS Analyzer prompt is the arrow (->), but you can modify the prompt by using

the SETPROMPT command.

The syntax for the RUN command follows:

RUN

is the TACL RUN command.

EMSA

is the program file name of the EMS Analyzer program.

run-option

is one of the following. This list describes commonly used RUN options. For a

complete list of RUN options, see the Tandem Advanced Command Language

(TACL) Reference Manual.

CPU cpu-number

specifies the number of the CPU in which EMS Analyzer is to run. cpu-

number is an integer in the range of 0 through 15. If you omit this option, EMS

Analyzer runs in the same processor as TACL. (If the CPU option is omitted and

a $CMON process exists, $CMON might specify a CPU other than the one in

which the current TACL process is running. For more information about

$CMON, see the Guardian Programmer’s Guide.)

IN [ file-name ]

specifies the input file for the EMS Analyzer process. If you do not include the

IN file-name, EMS Analyzer uses the IN file in effect for the current TACL

(usually your home terminal).

NAME [ $process-name ]

specifies the name you are assigning to EMS Analyzer. Specify the

$process-name as an alphanumeric string of 1 to 5 characters, the first of

EMSA - T9671C30 - (01NOV91) (15DEC91) - 11/20/91 18:22:33 System \MTL

(Invoking $SYSTEM.STARTUP.EMSACSTM)

Confirm....... ON

EMSA CONSUMER DISTRIBUTOR $Z902 started

EMSA DISTRIBUTOR $Z902 altered: EMSLOG attribute

EMSA DISTRIBUTOR $Z902 altered: FILTER attribute

DISTRIBUTOR $Z902 1->

[ RUN ] EMSA [ / run-option / ]

[ command [ ; command ] ... ]