Event Management Service (EMS) Analyzer Manual

Using EMS Analyzer
Event Management Service (EMS) Analyzer Manual–133700
3-15
Using Online Help
To get a list of EMS Analyzer commands and to get help on using HELP, enter ALL at
the HELP prompt:
HELP : all
EMSA supports the following commands:
-------------------------- COMMANDS------------------------------------
The following are EMSA commands:
ALIAS ALLOW ALTER ASSIGN
ASSUME CLEAR COMMENT CONFIRM
CPUS DELAY DETAIL DUMPLOG
ENV EXIT FC HELP
HISTORY INFO LOG OBEY
OUT PAGESIZE PARAM PAUSE
REPEAT RUN SETPROMPT START
STATUS STOP SYSTEM TIMEOUT
VERSION VOLUME ! ?
--------------------- HOW TO USE HELP ---------------------------------
The HELP command displays a detailed description of commands,
object types, and basic components. There are two modes
of help operation--line mode and menu mode. Help text is accessed
in line mode (when the prompt is "->") by entering the full help
command (e.g. "HELP EMSA STATUS"). Help text is accessed in
menu mode (when the prompt is "HELP :") by entering each part of the
command in answer to the prompting text. EMSA is in line mode by
default. To enter menu mode type "HELP" followed by the return key.
Menu mode help can only be used in interactive mode. If HELP<CR>
is entered during a non-interactive EMSA session, HELP ALL (this text)
will be displayed.
To obtain a description of the help command while in line mode
type "HELP HELP <return>" or while in menu mode type "EMSA <return>
HELP <return>".
The help key (F16) is used to show all of the valid options at any
point in a command. For a complete description of the help key
while in line mode type "HELP HELP-KEY <return>" or while in menu
mode type "HELP-KEY <return>".