Exchange/RJE Manual

Trace Server Messages
Exchange/RJE Messages
A–6 104698 Tandem Computers Incorporated
RJCI16E CONNECTION TO $ server STILL EXISTS
RJCI16* ISSUE A 'DISCONNECT' TO BREAK CONNECTION
Problem. You have entered a CONNECT command while the command interpreter is
still connected to a line server.
Solution. Use the existing line server and connection (if suitable), or enter a
DISCONNECT command and then enter the CONNECT command again.
RJCI17E COULD NOT CREATE A UNIQUE SERVER NAME FOR SYSTEM
system-name , system-number
Problem. The operating system was unable to create the process.
Solution. Try the operation again at a later time, or name the line server with the SET
command and then try the operation again.
RJCI18E parameter-name HAS NOT BEEN SPECIFIED
Problem. The indicated parameter ( parameter-name ) must be specified before you
can perform the operation. Typically, this error message is issued when you enter a
CONNECT command without first specifying the data communications line that you
want to use (which is specified in the LINE parameter of the SET command).
Solution. Specify the parameter, and then enter the command again.
RJCI19E BLOCKING PARAMETER REQUIRES THAT A BLOCKSIZE BE
SPECIFIED.
Problem. You specified BLOCKING ON in an RJECIR or SET command but did not
specify a value for BLOCKSIZE.
Solution. Use the SET command to specify a value for BLOCKSIZE or to specify
BLOCKING OFF.