Exchange/RJE Manual

Send/Receive Server Messages
Exchange/RJE Messages
104698 Tandem Computers Incorporated A–19
RJCI81E RETRIES COUNT MUST BE -1, ZERO, OR POSITIVE INTEGER
Problem. You have entered an invalid value for the RETRIESEOT or RETRIESIDLE
parameter.
Solution. Enter the command again, specifying a valid value.
RJCI82E A REMOTE SYSTEM NAME MUST BE SPECIFIED IN BOTH PROGRAM
AND USERLIB
Problem. You have entered both the PROGRAM and USERLIB parameters with a
remote system name specified in only one of the two parameters. Or, you have
entered the USERLIB parameter with a remote system name and have not specified
the PROGRAM parameter. The operation is aborted.
Solution. Specify the remote system name in both the PROGRAM and USERLIB
parameters. Perform the operation again.
RJCI99F INTERNAL PROGRAM ERROR - number
Problem. An internal program error has occurred.
Solution. Contact your local Tandem support office. Note the number displayed and
the conditions under which the error occurred.
Send/Receive Server
Messages
This subsection lists the messages issued by the Exchange/RJE send/receive server.
Some of the messages are shown here on two lines even though the messages are
displayed on a single line on your screen.
Some message explanations indicate that you should contact your local Tandem
support office. Before calling the office, please gather the information outlined in the
section “Before Contacting Tandem,” later in this appendix.
RJSR00 FILE name IS BEING sent/received
RJSR00* to/from server AT hh:mm:ss ON mm/dd/yy
Comment. The specified file is being transferred.