Exchange/SNA Manual

RESET Command
Exchange/SNA Commands
104700 Tandem Computers Incorporated 3–41
RESET Command The RESET command sets one or more configuration parameters to their default
values.
RESET { * | parameter [ parameter ]... }
*
sets all configuration parameters to their default values. See the description of
parameter , below, for a list of the configuration parameters and their default
values.
parameter
is one of the following terms:
AU[TOLOGON] { ON | OFF }
If you specify AUTOLOGON ON, the logon request is not sent to the host and
Exchange/SNA waits for the host to send the BIND command.
If you specify AUTOLOGON OFF, the logon request (either a character-coded
logon command or an INIT-SELF command) is sent to the host.
The default value for AUTOLOGON is OFF.
COM[MAND]
sets the command character to the null character. In this case, there is no
command character and thus no way to send messages to the host RJE
subsystem.
CON[SOLE]
sets the console to none. In this case, there is no console subdevice.
EN[DTIMED]
resets the timer value to 15 seconds.
HO[ST]
sets the host RJE subsystem specification to an undefined state. The host RJE
subsystem must be specified before you start a line server.
LI[NE]
sets the data communications line to an undefined state. In this case, the data
communications line to be used is not defined.