Expand Configuration and Management Manual (G06.24+)

Configuration Overview
Expand Configuration and Management Manual—523347-008
5-2
Summary of Configuration Steps
Summary of Configuration Steps
Configuring the Expand subsystem involves a number of steps. Table 5-1 lists each
step and indicates where in this manual the step is described.
Table 5-1. Configuration Steps
Step Description Where This Step Is Described
1. Start the Expand manager
process.
For step 1, information is located in Starting the
Expand Manager Process on page 5-4 of this
section.
2.
3.
Create a profile for the
network control process at
each node in the Expand
network.
Create and start the
network control process at
each node in the Expand
network.
For steps 2 and 3, information is located in
Section 6, Configuring the Network Control
Process.
4.
5.
6.
Create profiles for the
Expand line-handler
processes.
Create and start the Expand
line-handler processes.
Start the Expand lines.
For steps 4 through 6, information is located in one
of the following sections. Which section you select
depends on the type of Expand line-handler
process that you want to configure:
Section 7, Configuring Direct-Connect and Satellite-
Connect Lines
Section 8, Configuring Expand-Over-IP Lines
Section 9, Configuring Expand-Over-ATM Lines
Section 10, Configuring Expand-Over-X.25 Lines
Section 11, Configuring Expand-Over-SNA Lines
Section 12, Configuring Expand-Over-ServerNet
Lines
Section 13, Configuring Expand-Over-FOX Lines
Section 14, Configuring Multi-Line Paths