Expand Configuration and Management Manual (G06.24+)

Configuring Direct-Connect and Satellite-Connect
Lines
Expand Configuration and Management Manual—523347-008
7-10
ADD DEVICE Command
CPU cpunumber
indicates the processor where this Expand line-handler process will normally
execute. HP recommends that you specify the same processor as that configured
for the preferred NonStop TCP/IP process used by the SWAN concentrator
specified by concname.
ALTCPU altcpunumber
indicates the processor where the backup Expand line-handler process will
normally execute. HP recommends that you specify the same processor as that
configured for the alternate NonStop TCP/IP process used by the SWAN
concentrator specified by concname.
TYPE (63,5)
is the device type and subtype for this Expand line-handler process. The device
type is always 63 for Expand line-handler processes. The subtype is 5 for both
single-line direct-connect and satellite-connect line-handler processes.
RSIZE rsize
specifies the time factor of the line for the Expand routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
ADAPTER concname
is the SWAN concentrator you selected for use by this Expand line-handler
process in Step 1: Find an Available WAN Line on page 7-6.
CLIP clipnum
is the CLIP number on the SWAN concentrator specified by concname that
contains an available WAN line. Refer to Step 1: Find an Available WAN Line on
page 7-6 for information about identifying CLIP numbers.Valid values are 1, 2, or 3.
LINE linenum
is the number of an available WAN line on the CLIP specified by clipnum. Refer
to Step 1: Find an Available WAN Line on page 7-6 for information about identifying
line numbers. Valid values are 0 or 1.
PATH { A | B }
is the path (A or B) on the CLIP specified by clipnum that you prefer. The path
must be configured.
NEXTSYS sys_number
is a required modifier that specifies the number (from 0 to 254) of the system
connected to the other end of the line. If you do not specify the NEXTSYS modifier,
it defaults to an invalid value (255) and an operator message occurs during the