Expand Configuration and Management Manual (G06.24+)

Configuring Direct-Connect and Satellite-Connect
Lines
Expand Configuration and Management Manual—523347-008
7-12
Step 4: Start the Line-Handler Process
In the last example, a device named $DIR2 is created for a direct-connect line-handler
process that uses a SWAN concentrator named S02. $DIR2 is also a member of a
multi-CPU path. The SUPERPATH_ON and L4EXTPACKETS_ON modifiers are
required for line-handler processes that are part of a multi-CPU path. The
L4CONGCTRL_ON modifier is recommended for Expand line-handler processes that
are part of a multi-CPU path.
-> ADD DEVICE $ZZWAN.#DIR2, PROFILE SLHTER, IOPOBJECT &
$SYSTEM.SYSTEM.LHOBJ, CPU 0, ALTCPU 1, TYPE (63,5), RSIZE 0, &
PATHTF 3, CLIP 2, LINE 0, ADAPTER S02, PATH A, NEXTSYS 13, &
14EXTPACKETS_ON, 14CONGCTRL_ON, SUPERPATH_ON
Step 4: Start the Line-Handler Process
To start a single-line direct-connect or satellite-connect line-handler process, use the
WAN subsystem SCF START DEVICE command. The command syntax is as follows:
$ZZWAN.device_name
specifies, via the WAN subsystem, the device name of the direct-connect or
satellite-connect Expand line-handler process.
This command creates the specified Expand line-handler process and allocates a
logical device (LDEV) number.
Step 5: Start the Line
To start the path and line functions of a single-line direct-connect or satellite-connect
line-handler process, use the Expand subsystem SCF START LINE command. The
command syntax is as follows:
device_name
is the device name of the direct-connect or satellite-connect Expand line-handler
process.
The successful completion of this command leaves the line in the STARTED state.
START DEVICE $ZZWAN.#device_name
START LINE $device_name