Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-IP Lines
Expand Configuration and Management Manual—523347-008
8-8
Summary of Configuration Steps
Summary of Configuration Steps
Once all hardware and software requirements have been met (refer to Required
Hardware and Software on page 8-2 for details), configuring and starting a single-line
Expand-over-IP line-handler process involves the following steps. Use Steps A or B
depending on which version of TCP/IP you want to use.
Step Tool Used
Step 1 (A): Select a Process and SUBNET for NonStop
TCP/IP Use
SCF interface to the
NonStop TCP/IP
subsystem
Step 1 (B): Select a TCPSAM Process and SUBNET for
Parallel Library TCP/IP Use
SCF interface to the
Parallel Library TCP/IP
subsystem
Step 1 (C): Select a Process and SUBNET for NonStop
TCP/IPv6 Use
SCF interface to the
NonStop TCP/IPv6
subsystem
Step 2 (A): Identify an Available UDP Port Number
SCF interface to the
NonStop TCP/IP
subsystem
Step 2 (B): Identify an Available UDP Port Number for Parallel
Library TCP/IP Use
SCF interface to the
Parallel Library TCP/IP
subsystem
Step 2 (C): Identify an Available UDP Port Number for
TCP/IPv6 Use
SCF interface to the
NonStop TCP/IPv6
subsystem
Step 3: Create a Profile for the Line-Handler Process
SCF interface to the WAN
subsystem
Step 4: Create the Line-Handler Process
SCF interface to the WAN
subsystem
Step 5: Start the Line-Handler Process
SCF interface to the WAN
subsystem
Step 6: Start the Line
SCF interface to the
Expand subsystem
Note. The SCF command syntax shown in this section is the syntax used to configure
Expand-over-IP line-handler processes; it is not meant to show the complete syntax of SCF
commands described. Refer to the following for more information:
•
TCP/IP Configuration and Management Manual
•
TCP/IP (Parallel Library) Configuration and Management Manual
•
TCP/IPv6 Configuration and Management Manual
•
WAN Subsystem Configuration and Management Manual
•
Section 15, Subsystem Control Facility (SCF) Commands