Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-IP Lines
Expand Configuration and Management Manual—523347-008
8-13
Step 1 (C): Select a Process and SUBNET for
NonStop TCP/IPv6 Use
Step 1 (C): Select a Process and SUBNET for
NonStop TCP/IPv6 Use
Step 1 (C) is for use with NonStop TCP/IPv6 only.
Select a SUBNET for NonStop TCP/IPv6 Use
NonStop TCP/IPv6 only supports SUBNETs of type Ethernet. A NonStop TCP/IPv6
SUBNET associates the NonStop TCP/IPv6 environment with a connection to a
network and an IP address.
To obtain a list of running IPv6 and IPv6 SUBNETs, issue the following SCF command:
> INFO SUBNET $ZZTCP.*, DETAIL
Example 8-5 shows a sample result of the SCF INFO SUBNET, DETAIL command.
Note. The following instructions assume that a NonStop TCP/IPv6 environment has already
been started. For information about starting a NonStop TCP/IPv6 environment, refer to the
TCP/IPv6 Configuration and Management Manual.
Note. For NonStop TCP/IPv6, we use the SCF INFO SUBNET command to the manager
process ($ZZTCP) for the example because it shows IPv6 address whereas the SCF INFO
SUBNET command to the TCP6SAM process shows only IPv4 addresses. If you are using
NonStop TCP/IPv6 in INET mode (IPv4 addresses only), you can issue the INFO SUBNET
command to the TCP6SAM process just like in the procedure for Parallel Library TCP/IP.