Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-IP Lines
Expand Configuration and Management Manual—523347-008
8-24
Considerations
V6DESTIPADDR v6destip-address
if IPVER is IPv6, this is a required modifier that specifies the IP address used by
the remote (destination) Expand-over-IP line-handler process. It is the IP address
specified in the remote line-handler process’ V6SRCIPADDR modifier.
v6dest_ipaddr must be specified by number (for example,
1611:1071:F881:1167:1611:A071:1881:B167). Selecting IP addresses is described
in Step 1 (C): Select a Process and SUBNET for NonStop TCP/IPv6 Use. It is not
validated and need not be accessible. (This attribute applies to NonStop TCP/IPv6
only.)
NEXTSYS sys_number
is a required modifier that specifies the number (from 0 through 254) of the system
connected to the other end of the line. If you do not specify the NEXTSYS modifier,
it defaults to an invalid value (255), and an operator message occurs during the
initialization of the Expand-over-IP line-handler process. The path will not be
operational until you alter the NEXTSYS modifier to a valid value using either the
WAN subsystem SCF ALTER DEVICE command or the Expand subsystem SCF
ALTER PATH command.
modifier_keyword
is the name of an optional modifier in profile_name. modifier_keyword is
added to the device record for this Expand line-handler process.
Modifier names in the PEXQSIP profile are listed in Profile Modifiers on page 8-28.
modifier_value
is the value you want to assign to the optional modifier specified by
modifier_keyword. modifier_value assigns a value to modifier_keyword
in the device record for this Expand line-handler process.
Default values and ranges of values for modifiers in the PEXQSIP profile are
described in Profile Modifiers
on page 8-28.
Considerations
•
Not all modifiers have associated values (for example, L4EXTPACKETS_ON).
•
The modifier_keyword and modifier_value parameters do not add the
specified modifier, or a modifier and its associated value, to the profile used by the
device. Use the ADD PROFILE command to add a modifier, or a modifier and its
associated value, to a profile.