Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-ATM Lines
Expand Configuration and Management Manual—523347-008
9-9
Configuring an Expand Line-Handler Process That
Uses ATMSAP
Configuring an Expand Line-Handler Process That Uses
ATMSAP
The SLSA ATMSAP connection offers an ATM Native Mode network interconnect
support similar to that offered by the PVC object within the ATM subsystem. Expand
issues native mode frames directly to the ATM product via a LIF associated with an
ATMSAP object.
Figure 9-3 illustrates ATMSAP use by Expand.
For more information on ATMSAP objects, including their management by the SCF
ABORT, ADD, ALTER, DELETE, INFO, NAMES, START, STATS, STATUS, and STOP
commands, refer to the LAN Configuration and Management Manual.
To configure an ATMSAP object:
1. Use the ADD ATMSAP command to add an ATMSAP object. You can add a
maximum of 128 ATMSAP objects per PIF object. Following is an example of the
ADD ATMSAP command:
ADD [ /OUT file-spec/ ] ATMSAP $ZZLAN.ATM01.0.A.ATMSAP01, &
VCC (vpi, vci)
The example above adds an ATMSAP object named
$ZZLAN.ATM01.0.A.ATMSAP01.
2. Add a LIF Object to an ATMSAP Object. Use the ADD LIF command to configure a
LIF for each ATMSAP object. Following is an example of the ADD LIF command
that adds a LIF object and associates it with an ATMSAP object.
ADD LIF $ZZLAN.LIF01, ATMSAP ATM01.0.A.ATMSAP01
The example above adds a LIF object named $ZZLAN.LIF01 and associates it to
an ATMSAP object named $ZZLAN.ATM01.0.A.ATMSAP01.
Figure 9-3. Expand and ATMSAP
CPU
LIF
Expand LH
Process
Line
003CDT .CDD
CPU
Expand LH
Process
ATMSAP
ATM3SA
ATMSAP
ATM3SA
LIF Line