Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-ATM Lines
Expand Configuration and Management Manual—523347-008
9-10
Step 2: Create a Profile for the Line-Handler Process
Verifying the Line-Handler Process
Example 9-4 shows an example of an Expand subsystem SCF INFO LINE command
with the DETAIL option of an Expand-over-ATM line-handler process named
$ATM2BAT and a CallType of ATMSAP.
Example 9-5 shows examples of altering the modifier CALLTYPE and the LIFNAME of
an Expand-over-ATM line-handler process named $ATM2BAT.
Step 2: Create a Profile for the Line-Handler
Process
You can create a profile for a single-line Expand-over-ATM line-handler process using
the PEXQSATM profile. This profile is provided in the $SYSTEM.SYSnn subvolume.
You can also create a new profile from an existing profile, or you can create your own
profile. For complete information about profiles, refer to the WAN Subsystem
Configuration and Management Manual.
This subsection shows you how to create a profile using PEXQSATM.
Example 9-4. Expand Subsystem SCF INFO LINE, DETAIL Command for
ATMSAP
-> INFO LINE $ATM2BAT, DETAIL
EXPAND Detailed Info LINE $ATM2BAT (LDEV 613)
L2Protocol Net^Atm TimeFactor... 26K *SpeedK... OC3
Framesize.... 132 -Rsize.... -Speed...
*LinePriority... 1 StartUp... OFF Delay... 0:00:00.10
*DownIfBadQuality OFF *QualityThreshold 96 *QualityTimer 0:01:00.00
*Txwindow... 7 *Maxreconnects... 0 *AfterMaxRetries PASSIVE
*Timerreconnect 0:00:30.00 *Retryprobe……. 3 *Timerprobe… 0:00:30.00
*CallType... ATMSAP *LifName.. ATM2LIF *Timerinactivity 0:00:00.00
Example 9-5. Altering the CALLTYPE Modifier and LIFNAME
-> ALTER LINE $ATM2BAT, CALLTYPE ATMSAP
-> ALTER LINE $ATM2BAT, LIFNAME LIFEXP01
Note. Different profiles are provided for Expand-over-ATM lines that are part of a multi-line
path; these profiles are described in Section 14, Configuring Multi-Line Paths
.