Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-ATM Lines
Expand Configuration and Management Manual—523347-008
9-12
Step 3: Create the Line-Handler Process
Step 3: Create the Line-Handler Process
You create a single-line Expand-over-ATM line-handler process by adding it as a
device to the WAN subsystem.
ADD DEVICE Command
To create an Expand-over-ATM line-handler process, use the WAN subsystem SCF
ADD DEVICE command. The command syntax depends on whether you use a PVC,
SVC, or ATMSAP connection.
Syntax for PVC Connections
Use the following command syntax if the Expand-over-ATM line-handler process will
use a PVC connection:
Note. This section explains how to configure single-line Expand-over-ATM line-handler
processes only. Creating an Expand-over-ATM line that is part of a multi-line path is explained
in Section 14, Configuring Multi-Line Paths
.
ADD DEVICE $ZZWAN.#device_name
, IOPOBJECT $SYSTEM.SYSnn.LHOBJ
, PROFILE profile_name
, CPU cpunumber
, ALTCPU altcpunumber
, TYPE (63,0 )
, RSIZE rsize
, ASSOCIATEDEV $atm_line
, ASSOCIATESUBDEV #IP
, CALLTYPE_PVC
, PVCNAME pvc-name
, NEXTSYS sys_number
[, modifier_keyword [ modifier_value ] ] ...