Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-ATM Lines
Expand Configuration and Management Manual—523347-008
9-14
ADD DEVICE Command
CPU cpunumber
indicates the processor where this Expand line-handler process will normally
execute.
ALTCPU altcpunumber
indicates the processor where the backup Expand line-handler process will
normally execute.
TYPE (63,0)
is the device type and subtype for this Expand line-handler process. The device
type is always 63 for Expand line-handler processes. The subtype is 0 for single-
line Expand-over-ATM line-handler processes.
RSIZE rsize
specifies the time factor of the line for the Expand routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
ASSOCIATEDEV atm-line
specifies the device name of the ATM line you want to associate with this Expand-
over-ATM line-handler process, for example, $ATM1. This parameter is required.
ASSOCIATESUBDEV #IP
identifies the ATM service access point (SAP). The only currently supported ATM
SAP is #IP.
CALLTYPE_PVC
indicates that a permanent virtual circuit (PVC) connection will be used.
CALLTYPE_SVC
indicates that a switched virtual circuit (SVC) connection will be used.
CALLTYPE_ATMSAP
indicates that an ATMSAP connection through the SLSA subsystem will be used.
LIFNAME lif-name
is the name of the logical interface, which represents the name by which LAN
access is known to the system. This name can be up to 8 characters long, null-
terminated, and case-sensitive.
This modifier is only applicable to ATMSAP connections using the SLSA
subsystem.