Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-ATM Lines
Expand Configuration and Management Manual—523347-008
9-15
ADD DEVICE Command
PVCNAME pvc-name
is the name of the permanent virtual circuit (PVC) that will be used. This is the PVC
name you identified in Step 1: Identify the ATM Connection on page 9-5. For
example, PVC01.
This modifier is only applicable to Expand-over-ATM line-handler processes that
use PVC connections.
ATMSEL selector-byte
is a hexadecimal selector byte for the ATM line used by this Expand-over-ATM
line-handler process. This is the selector byte you obtained in Obtaining Selector
Bytes for the Local and Remote ATM Lines on page 9-6.
This modifier is only applicable to Expand-over-ATM line-handler processes that
use SVC connections.
DESTATMADDR (ISONSAP:%Hatm-address)
is the 20-byte hexadecimal ATM address configured for the ATM line used by the
Expand-over-ATM line-handler process at the remote system. This is the ATM
address you identified in Identifying the ATM Address Configured for the Remote
ATM Line on page 9-7. The last byte of this ATM address must be the selector byte
you obtained for the remote ATM line as described in Obtaining Selector Bytes for
the Local and Remote ATM Lines on page 9-6. The address must be preceded by
the characters ISONSAP:%H and must be enclosed in parentheses. For example:
(ISONSAP:%H47000580FFE1000000F21A29EB0000000001B381)
This modifier is only applicable to Expand-over-ATM line-handler processes that
use SVC connections.
NEXTSYS sys_number
is a required modifier that specifies the number (from 0 through 254) of the system
connected to the other end of the line. If you do not specify the NEXTSYS modifier,
it defaults to an invalid value (255), and an operator message occurs during the
initialization of the Expand-over-ATM line-handler process. The path will not be
operational until you alter the NEXTSYS modifier to a valid value using either the
WAN subsystem SCF ALTER DEVICE command or the Expand subsystem SCF
ALTER PATH command.
modifier_keyword
is the name of an optional modifier in profile_name. modifier_keyword is
added to the device record for this Expand line-handler process.
Modifier names in the PEXQSATM profile are listed in Profile Modifiers on
page 9-17.