Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-ATM Lines
Expand Configuration and Management Manual—523347-008
9-17
Step 4: Start the Line-Handler Process
In the last example, a device named ATMLIN3 is created for a single-line Expand-over-
ATM line-handler process that uses an ATMSAP connection through the SLSA
subsystem.
-> ADD DEVICE $ZZWAN.#ATMLIN3, PROFILE SLHATM, IOPOBJECT &
$SYSTEM.SYSTEM.LHOBJ, CPU 0, ALTCPU 1, TYPE (63,0), RSIZE 0, &
PATHTF 3, NEXTSYS 251, CALLTYPE_ATMSAP, LIFNAME LIF01
Step 4: Start the Line-Handler Process
To start a single-line Expand-over-ATM line-handler process, use the WAN subsystem
SCF START DEVICE command. The command syntax is as follows:
$ZZWAN.device_name
specifies, via the WAN subsystem, the device name of the Expand-over-ATM
line-handler process.
This command creates the specified Expand line-handler process and allocates a
logical device (LDEV) number.
Step 5: Start the Line
To start an Expand-over-ATM line, use the Expand subsystem SCF START LINE
command. The command syntax is as follows:
device_name
is the device name of the Expand-over-ATM line-handler process.
The successful completion of this command leaves the line in the STARTED state.
Profile Modifiers
This subsection lists the recommended modifiers for single-line Expand-over-ATM
line-handler processes and describes the modifiers provided for configuring special
features. It also describes default values and value ranges for all the modifiers
contained in the PEXQSATM profile.
START DEVICE $ZZWAN.#device_name
START LINE $device_name
Note. A different profile is provided for Expand-over-ATM lines that are part of a multi-line
path; this profile is described in Section 14, Configuring Multi-Line Paths
.