Expand Configuration and Management Manual (G06.24+)
Configuring Expand-Over-X.25 Lines
Expand Configuration and Management Manual—523347-008
10-9
ADD Profile Command
ADD Profile Command
To create a profile from the PEXQSNAM profile template, use the WAN subsystem
SCF ADD PROFILE command. The command syntax is as follows:
$ZZWAN.profile_name
specifies, via the WAN subsystem, a user-defined name of up to 8 alphanumeric
characters that will be used to identify the new profile. You will reference this
profile_name when you create a device for the line-handler process in Step 4:
Create the Expand-Over-X.25 Line-Handler Process.
FILE $SYSTEM.SYSnn.profile_filename
specifies the name of an existing disk file that will be used to create the new
profile. PEXQSNAM is the disk filename of the profile provided for Expand-over-
NAM line-handler processes.
modifier_keyword
is the name of a modifier in profile_name. Modifier names in the PEXQSNAM
profile are listed in Profile Modifiers on page 10-13.
modifier_value
is the value you want to assign to the modifier specified by modifier_keyword.
Specifying a modifier_value assigns a new value to modifier_keyword in
profile_name. Default values and ranges of values for modifiers in the
PEXQSNAM profile are described in Profile Modifiers on page 10-13.
Example
In the following example, a profile named SLHX25 is created for a single-line Expand-
over-X.25 line-handler process using the PEXQSNAM profile. The COMPRESS_OFF
modifier is added to the profile.
-> ADD PROFILE $ZZWAN.#SLHX25, FILE $SYSTEM.SYS01.PEXQSNAM, &
COMPRESS_OFF
ADD PROFILE $ZZWAN.#profile_name
, FILE $SYSTEM.SYSnn.profile_filename
[, modifier_keyword [ modifier_value ] ] ...