Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-SNA Lines
Expand Configuration and Management Manual—523347-008
11-7
Summary of Configuration Steps
Summary of Configuration Steps
Once all hardware and software requirements have been met (refer to Required
Hardware and Software on page 11-1 for details), configuring and starting a single-line
Expand-over-SNA line-handler process involves the following steps:
Step Tool Used
Step 1: Add the SNAX/APN Line
SCF interface to the
SNAX/APN subsystem
Step 2: Add the LUs for the SNAX/APN Line
SCF interface to the
SNAX/APN subsystem
Step 3: Start the SNAX/APN Line
SCF interface to the
SNAX/APN subsystem
Step 4: Create a Profile for the Expand-Over-SNA Line-
Handler Process
SCF interface to the WAN
subsystem
Step 5: Create the Expand-Over-SNA Line-Handler Process
SCF interface to the WAN
subsystem
Step 6: Start the Expand-Over-SNA Line-Handler Process
SCF interface to the WAN
subsystem
Step 7: Start the Expand-Over-SNA Line
SCF interface to the
Expand subsystem
Note. The SCF command syntax shown in this section is the syntax used to configure
Expand-over-SNA line-handler processes; it is not meant to show the complete syntax of the
SCF commands described. Refer to the following manuals for more information:
•
SNAX/XF and SNAX/APN Configuration and Management Manual for SNAX/APN
subsystem commands
•
WAN Subsystem Configuration and Management Manual for WAN subsystem SCF
commands
•
Section 15, Subsystem Control Facility (SCF) Commands, for Expand subsystem SCF
commands