Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-SNA Lines
Expand Configuration and Management Manual—523347-008
11-9
Considerations
For details about configuring LUs and PUs, and SCF ADD LU and ADD PU command
attributes, refer to the SNAX/XF and SNAX/APN Configuration and Management
Manual.
Considerations
The following configuration considerations apply to local LU object attributes:
•
The PROTOCOL attribute must be set to NAM.
•
The local SNANAME on one system must match the remote LU SNANAME on the
other system.
•
If the local LU is to initiate sessions, DLUNAME must be defined (matching the last
part of the remote LU object name). If the remote PU has DYNAMIC ON, remote
LUs will always be able to initiate sessions. However, DLUNAME must be specified
in one of the two systems in order for the connection to become active.
Example
Figure 11-3 shows the SCF commands used to configure a SNAX/APN line, local LU,
remote PU, and remote LU at two nodes in an Expand network.