Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-SNA Lines
Expand Configuration and Management Manual—523347-008
11-13
ADD DEVICE Command
$ZZWAN.#device_name
specifies, via the WAN subsystem, the device name of the Expand line-handler
process to add.
IOPOBJECT $SYSTEM.SYSnn.LHOBJ
is the name of the object file containing the executable object for code for an
Expand line-handler process. This value must be $SYSTEM.SYSnn.LHOBJ.
PROFILE profile_name
is the name of the profile you created for this Expand line-handler process in Step
4: Create a Profile for the Expand-Over-SNA Line-Handler Process.
CPU cpunumber
indicates the processor where this Expand line-handler process will normally
execute.
ALTCPU altcpunumber
indicates the processor where the backup Expand line-handler process will
normally execute.
TYPE (63,0)
is the device type and subtype for this Expand line-handler process. The device
type is always 63 for Expand line-handler processes. The subtype is 0 for single-
line Expand-over-SNA line-handler processes.
RSIZE rsize
specifies the time factor of the line for the Expand routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
ASSOCIATEDEV nam_process
specifies the device name of the SNAX/APN line-handler process you want to
associate with this Expand-over-SNA line-handler process.
ASSOCIATESUBDEV subdevice
is a required modifier that specifies the name of the SNAX/APN subdevice to which
the Expand-over-SNA line-handler process will bind. subdevice is a local LU
(with the NAM protocol) defined for the SNAX/APN line-handler process specified
with the ASSOCIATEDEV modifier. Adding LUs is explained in Step 2: Add the LUs
for the SNAX/APN Line on page 11-8.