Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-ServerNet Lines
Expand Configuration and Management Manual—523347-008
12-10
ADD DEVICE Command
ALTCPU altcpunumber
indicates the processor where the backup Expand-over-ServerNet line-handler
process will normally execute.
TYPE (63,4)
is the device type and subtype for Expand-over-ServerNet line-handler processes.
The device type is always 63 for Expand line-handler processes. The subtype is
always 4 for Expand-over-ServerNet line-handler processes.
RSIZE rsize
specifies the time factor of the line for the Expand routing algorithm. RSIZE can be
0 if the time factor is set using some other modifier.
ASSOCIATEDEV $ZZSCL
specifies the device name of the ServerNet cluster monitor process, $ZZSCL.
$ZZSCL is the default, but it can be changed.
NEXTSYS sys_number
is a required modifier that specifies the Expand node number (from 0 to 254) of the
system connected to the other end of the line. If you do not specify NEXTSYS, this
modifier defaults to an invalid value (255), and an operator message occurs during
the initialization of the Expand-over-ServerNet line-handler process. The path will
not be operational until you alter NEXTSYS to a valid value using either the WAN
subsystem SCF ALTER DEVICE command, or the Expand subsystem SCF ALTER
PATH command.
modifier_keyword
is the name of a modifier in profile_name. modifier_keyword is added to the
device record for this Expand line-handler process.
Modifier names in the PEXPSSN profile are listed in Profile Modifiers
on
page 12-13.
modifier_value
is the value you want to assign to the modifier specified by modifier_keyword.
modifier_value assigns a value to modifier_keyword in the device record
for this Expand line-handler process.
Default values and ranges of values for modifiers in the PEXPSSN profile are
described in Profile Modifiers
on page 12-13.