Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-ServerNet Lines
Expand Configuration and Management Manual—523347-008
12-12
Step 3: Start the Expand-Over-ServerNet Line-
Handler Processes
Step 3: Start the Expand-Over-ServerNet Line-
Handler Processes
To start an Expand-over-ServerNet line-handler process, use the WAN subsystem SCF
START DEVICE command. You must start each Expand-over-ServerNet line-handler
process that you created in Step 2: Create a Device for the Expand-Over-ServerNet
Line-Handler Process. The command syntax is as follows:
$ZZWAN.device_name
specifies, via the WAN subsystem, the device name of the Expand-over-ServerNet
line-handler process.
This command creates the specified Expand line-handler process and allocates a
logical device (LDEV) number.
Example
In the following example, the device named #SC001 is started.
-> START DEVICE $ZZWAN.#SC001
Step 4: Start the Expand-Over-ServerNet Lines
To start an Expand-over-ServerNet line, use the Expand subsystem SCF command
START LINE. The command syntax is as follows:
device_name
is the device name of the Expand-over-ServerNet line-handler process.
The successful completion of this command leaves the line in the STARTED state. To
check the status of the line, enter the following SCF command:
START DEVICE $ZZWAN.#device_name
Note. Do not perform this step unless you have already physically connected the NonStop
S-series server to the ServerNet cluster. Connecting a NonStop S-series server to a ServerNet
cluster is described in the ServerNet Cluster Manual.
START LINE $device_name
Note. Wait about five seconds after starting the device before you start the line.
STATUS LINE $device_name