Expand Configuration and Management Manual (G06.24+)

Configuring Expand-Over-FOX Lines
Expand Configuration and Management Manual—523347-008
13-7
Considerations
ASSOCIATEDEV $ZZFOX
specifies the device name of the FOX monitor process, $ZZFOX. $ZZFOX is the
default, but it can be changed.
NEXTSYS sys_number
is a required modifier that specifies the number (from 0 to 254) of the system
connected to the other end of the line. If you do not specify NEXTSYS, this
modifier defaults to an invalid value (255), and an operator message occurs during
the initialization of the Expand-over-FOX line-handler process. The path will not be
operational until you alter NEXTSYS to a valid value using either the WAN
subsystem SCF ALTER DEVICE command, or the Expand subsystem SCF ALTER
PATH command.
modifier_keyword
is the name of a modifier in profile_name. modifier_keyword is added to the
device record for this Expand line-handler process.
Modifier names in the PEXQSFX profile are listed in Profile Modifiers on
page 13-8.
modifier_value
is the value you want to assign to the modifier specified by modifier_keyword.
modifier_value assigns a value to modifier_keyword in the device record
for this Expand line-handler process.
Default values and ranges of values for modifiers in the PEXQSFX profile are
described in Profile Modifiers on page 13-8.
Considerations
•
Not all modifiers have associated values (for example, L4EXTPACKETS_ON).
•
The modifier_keyword and modifier_value parameters do not add the
specified modifier, or a modifier and its associated value, to the profile used by the
device. Use the ADD PROFILE command to add a modifier, or a modifier and its
associated value, to a profile.
Example
In the following example, a device named $FXLH2 is created for an Expand-over-FOX
line-handler process.
-> ADD DEVICE $ZZWAN.#FXLH2, PROFILE SLHFX, IOPOBJECT &
$SYSTEM.SYSTEM.LHOBJ, CPU 0, ALTCPU 1, TYPE (63,3), &
RSIZE 0, PATHTF 3, ASSOCIATEDEV $ZZFOX, NEXTSYS 22