Expand Configuration and Management Manual (G06.24+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual—523347-008
14-5
Step 3: Create a Path-Logical Device
modifier_keyword
is the name of a modifier in profile_name. Modifier names in the line-logical
device profiles are listed in Line-Logical Device Modifiers on page 14-16.
modifier_value
is the value you want to assign to the modifier specified by modifier_keyword.
Specifying a modifier_value assigns a new value to modifier_keyword in
profile_name. Default values and ranges of values for modifiers in the line-
logical device profiles are described in Line-Logical Device Modifiers on
page 14-16.
Step 3: Create a Path-Logical Device
You create a path-logical device by adding a device to the WAN subsystem.
ADD DEVICE Command
To create a path-logical device, use the WAN subsystem SCF ADD DEVICE
command. The command syntax is as follows:
$ZZWAN.#path_name
specifies, via the WAN subsystem, the name of the path-logical device you want to
add.
Table 14-1. Profiles for Line-Logical Devices
Disk Filename Type of Line-Logical Device
PEXQMSWN Direct-connect
PEXQMSAT Satellite-connect
PEXQMNAM Expand-over-NAM
PEXQMIP Expand-over-IP
PEXQMATM Expand-over-ATM
ADD DEVICE $ZZWAN.#path_name
, IOPOBJECT $SYSTEM.SYSnn.LHOBJ
, PROFILE profile_name
, CPU cpunumber
, ALTCPU altcpunumber
, TYPE (63,1)
, RSIZE 0
, NEXTSYS sys_number
[, modifier_keyword [ modifier_value ] ] ...