Expand Configuration and Management Manual (G06.24+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual—523347-008
14-9
ADD DEVICE Command
Required Modifiers for Direct-Connect and Satellite-Connect
Lines
ADAPTER concname
is the ServerNet wide area network (SWAN) concentrator to be used by this line.
Selecting a SWAN concentrator is explained in Step 1: Find an Available WAN Line
on page 7-6. For information about adding SWAN concentrators, refer to the WAN
Subsystem Configuration and Management Manual.
CLIP clipnum
is the communications line interface processor (CLIP) number on the SWAN
concentrator specified by concname that contains an available WAN line. Refer to
Step 1: Find an Available WAN Line on page 7-6 for information about identifying
CLIP numbers. Valid values are 1, 2, and 3.
LINE linenum
is the number of an available WAN line on the CLIP specified by clipnum. Refer
to Step 1: Find an Available WAN Line on page 7-6 for information about identifying
line numbers. Valid values are 0 or 1.
PATH { A | B }
is the path (A or B) on the CLIP specified by clipnum that you prefer. The path
must be configured. For information about adding Ethernet paths, refer to the WAN
Subsystem Configuration and Management Manual.
modifier_keyword
is the name of an optional modifier in profile_name. modifier_keyword is
added to the device record for this line-logical device.
Modifier names in the line-logical device profiles are listed in Line-Logical Device
Modifiers on page 14-16.
modifier_value
is the value you want to assign to the optional modifier specified by
modifier_keyword modifier_value assigns a value to modifier_keyword
in the device record for this line-logical device.
Default values and ranges of values for modifiers in the line-logical device profiles
are described in Line-Logical Device Modifiers on page 14-16.