Expand Configuration and Management Manual (G06.24+)

Configuring Multi-Line Paths
Expand Configuration and Management Manual—523347-008
14-10
ADD DEVICE Command
Required Modifiers for Expand-Over-IP Lines
SRCIPADDR src_ipaddr
is a required modifier that specifies the IP address associated with the NonStop
TCP/IP process used by this Expand-over-IP line-handler process. Determining IP
addresses is described in Step 1 (A): Select a Process and SUBNET for NonStop
TCP/IP Use on page 8-9. The address must be specified by number (for example,
130.252.12.3). It is not validated and need not be accessible. The default is
0.0.0.1.
SRCIPPORT src_ipport
is a required modifier that specifies the User Datagram Protocol (UDP) port
number used by this Expand-over-IP line-handler process. Determining port
numbers is described in Step 2 (A): Identify an Available UDP Port Number on
page 8-16. Valid values are in the range 0 through 65534. The default is 1024. HP
recommends that you do not use a well-known port in the range from 0 through
1023.
DESTIPADDR dest_ipaddr
is a required modifier that specifies the IP address used by the remote
(destination) Expand-over-IP line. It is the IP address specified in the remote line’s
SRCIPADDR modifier. Determining IP addresses is described in Step 1 (A): Select
a Process and SUBNET for NonStop TCP/IP Use on page 8-9. The address must
be specified by number (for example, 130.252.12.3). It is not validated and need
not be accessible. The default is 0.0.0.1.
DESTIPPORT dest_ipport
is a required modifier that specifies the port number used by the remote
(destination) Expand-over-IP line. It is the port number specified in the remote line-
handler process’ SRCIPPORT modifier. Determining port numbers is described in
Step 2 (A): Identify an Available UDP Port Number on page 8-16. Valid values are
in the range 0 through 65534. The default is 1024. HP recommends that you do
not use a well-known port in the range from 0 through 1023.
V6DESTIPADDR v6dest_ipport
is a required modifier that specifies the IP address used by the remote NonStop
TCP/IPv6 (destination) Expand-over-IP line. It is the IP address specified in the
remote line’s V6SRCIPADDR modifier. Determining IP addresses is described in
Step 1 (C): Select a Process and SUBNET for NonStop TCP/IPv6 Use on
page 8-13. The address must be specified by number (for example,
1611:1071:F881:1167:1611:A071:1881:B167). It is not validated and need not be
accessible. The default is 0000:0000:0000:0000:0000:0000:0000:0000.